To Setup your Sygate Personal Home Firewall to work with SightSpeed please follow the instructions below:

1. Start Sygate Personal Home Firewall. Click on the Tools Menu on the menu bar and then click on Advanced Rules in the drop down menu. A warning will pop up about the dangers of configuring the firewall rules. Click Ok and move on to the pop up table. In the lower left hand corner click the ADD button which allows a new rule to be added to the firewall.

 
2. Under the tab labeled General, in the action section click on the radio button which says Allow this traffic. Once that is complete click on the tab labeled Ports and Protocols.

 
3. Under the option labeled Protocol select the option UDP. Two options will appear under the Protocol options, one labeled Remote and the other Local. Enter 9000 in each line. Click ok to accept the all the changes close the advanced rule settings.

Configure the SightSpeed Video Conference Receive Port

1. Open the SightSpeed client, and select Options -> Preferences
2. In the Preferences Wizard, advance to Network (Step 2 of 5)
3. In the Network section, click on the Advanced button
4. Under IP info, set the Receive Port to the corresponding port you set in step 2 of the Add SightSpeed as a Service section.
5. Click Finished and Restart SightSpeed Video Conferencing

You are now configured to use SightSpeed through your firewall, and free to see.

If you have any further questions, please contact support